5 Operation
5.2 Switch on/off power
Dentsply Sirona
Operating Instructions SiroLaser Blue
38
66 56 842 D3648
D3648.201.03.02.02 10.2018
5.2
Switch on/off power
Switch on the laser device
The LEDs will blink after starting the SiroLaser Blue by switching on the
on/off button on the backside of the control unit.
While the SiroLaser Blue is booting, information about the software
version and the set language as well as the note to read the user
manual will be displayed.
IMPORTANT
In some cases when the laser has been switched off for a longer time,
it may be necessary to press the on/off button two times to start the
unit.
When starting the SiroLaser Blue for the very first time, you will
automatically be asked to set-up the unit. Please proceed as requested:
1.
Language and country setting
For all users except US users: Change the pre-set country setting to
Non-US and confirm the selection.
Enter the pin code 3 3 3 4 and press 'OK '.
See also chapter "Language and country settings".
Ä
Now you will have access to the full range of pre-set
indications.
WARNING
It's forbidden to change the country setting to Non US if you belong to
US legal regulations. The use of the country setting Non US is not
authorized by the FDA.
2.
Date & time
Please enter the appropriate date & time and press 'OK'. See also
chapter "Date & time [→ 49]".
3.
User management
If requested, please change your profile or enter new profiles or
leave the first set-up by pressing the 'back' or 'home' button. See
also chapter "User management [→ 49]".
