Denso BHT-904B, User Manual

Page: 109 / 198

95
Barcode Handy Terminal

1.
nu and then press the
NT
key.
Th
rrent setting.
Pr
Pres
to display the NETWORK (
creen for
.
Pr (DHCP) screen to
retur T
quired IP configuration is displayed when the IP
teway is set to a value
the
Setting the DHCP
Select “3: DHCP” at the SET TCP/IP me
E
e SET DHCP screen displays as shown on the right. The highlighted
setting will be the cu
ess the Backspace/clear key to return to the SET TCP/IP menu.
s the dot key while holding down the
SF
key at the SET DHCP menu
DHCP) screen (acquisition check s
IP address at DHCP)
ess the Backspace/clear key at the NETWORK
n to the SE DHCP screen.

Point

If the ac
address, subnet mask or default ga
other than “0.0.0.0”, the DHCP does not display on
screen shown on the right.
BS/C
key
 
SF
+ [.] key
“1
Se imeo
The entry ran econds.

Point

Up to 32767 seconds can be entered, but in actual operation, a maximum of 190 seconds is
: TIMEOUT”:
ts the t ut for acquiring the IP configuration from the DHCP server.
ge is from 00001 to 32767 s
available since the number of retries and retry intervals are determined by the system.
To set the DHCP:
(1) Press the
ENT
key.
to entry mode and the cursor displays, allowing the setting to be entered with the
aracter, press the Backspace/clear key. To delete the entire entry, press and hold
keys simultaneously.
ue, and then press the
ENT
key.
(2) The mode changes
numeric keys.
To delete a single ch
the Backspace/clear key or press the
SF
and Backspace/clear
(3) Enter the desired val
Press the Backspace/clear key to return to the SET FTP menu.