Delta Tau PMAC Pack, Hardware Reference Manual

Page: 65 / 121

PMAC-Pack
54 PMACPack Custom Configuration
E49: Serial Communications Parity Control
Table 4-17. E49: Serial Communications Parity Control
E Point &
Physical Layout
Location Description Default
E49
C2 Jump pin 1 to 2 for NO serial parity; remove jumper for
ODD serial parity. Jumper installed
E50: EAROM Save Enable/Disable
Table 4-18. E50: EAROM Save Enable/Disable
E Point &
Physical Layout
Location Description Default
E50
C2 Jump pin 1 to 2 to enable save to EAROM; remove
jumper to disable save to EAROM. Jumper installed
E51: Normal/Re-Initializing Power-Up
Table 4-19. E51: Normal/Re-Initializing Power-Up
E Point &
Physical Layout
Location Description Default
E51
C2 Jump pin 1 to 2 to re-initialize ON power-up/reset;
remove jumper for NORMAL power-up/reset.
Note:
In PMAC-Pack, this jumper is connected to the
front panel RE-INIT.
No jumper installed
E55 - E65: Host Interrupt Signal Select
These jumpers work together with E86 and E76-E84 to set the mapping of PMAC information to host PC
bus interrupt lines. (They are of no relevance to PMAC-Pack operation.)
E66 - E71: Bus Base Hardware Address
These jumpers work with E91 & E92 to set the base address of PMAC-Lite on the PC bus. (They are of
no relevance to PMAC-Pack operation).