Delta Tau PMAC Pack, Hardware Reference Manual

Page: 59 / 121

PMAC-Pack
48 PMACPack Custom Configuration
Table 4-5. E7: Machine Input Source/Sink Control
E Point &
Physical Layout
Location Description Default
E7
C1 Jump pin 1 to 2 to apply +5V to input reference resistor
sip pack; this will bias MI1 to MI8 inputs to +5V for
"OFF" state; input must then be grounded for "ON"
state.
Jump pin 2 to 3 to apply GND to input reference
resistor sip pack; this will bias MI1 to MI8 inputs to
GND for "OFF" state; input must then be pulled up for
"ON" state (+5V to +24V).
Note:
When used in the PMAC-Pack with the
backplane board, 2-3 jumper must be installed.
1-2 Jumper installed
E9, E10, E13, E14: Handshake Control
E9, E10, E13, E14 jumpers control various configurations of RS422/RS232 handshake signal setup.
Table 4-6. E9, E10, E13, E14: Serial Interface Handshake Control
E Point &
Physical Layout
Location Description Default
E9 E10
E1 Jump, E9-1 to E9-2 to allow 'TXD/' to be input on J4-3;
jump E10-1 to E10-2 to allow 'RXD/' to be output on
J4-5.
Jump E9-1 to E10-1 to allow 'TXD/' to be output on J4-
3; jump E9-2 to E10-2 to allow 'RXD/' to be input on
J4-5.
1-2 Jumper installed
E13 E14
E1 D5 jump E13-1 to E13-2 to 1-2 allow 'RTS' to be input
jumper on J4-4; jump E14-1 to installed E14-2 to allow
'CTS' to be output on J4-6.
Jump E13-1 to E14-1 to allow 'RTS' to be output on J4-
4; jump E13-2 to E14-2 to allow 'CTS' to be input on
J4-6.
1-2 Jumper installed