Dell PowerConnect J-EX4500, Hardware Manual

Page: 46 / 226

Figure 19 on page 30 shows the Virtual Chassis module.
Figure 19: Virtual Chassis Module
The Virtual Chassis module has two LEDs (labeled ST and VC MODE ) on the left side
of its faceplate that indicate the status and the operating mode of the Virtual Chassis
module. See Figure 20 on page 30.
Figure 20: Virtual Chassis Module LEDs
Table 13 on page 30 describes the LEDs on the Virtual Chassis module in a J-EX4500
switch.
Table 13: Virtual Chassis Module LEDs
Description State LED
The Virtual Chassis module is functioning
normally. Green ST (status)
One of the following:
• The Virtual Chassis module is not
functioning normally.
• The switch has been powered off.
Unlit
The Virtual Chassis module and VCPs are
active. Green VC Mode
The Virtual Chassis module is operating in
Intraconnect mode. The VCPs are not active. Unlit
The Virtual Chassis module has two captive screws on the faceplate that secure the
module to the switch chassis. To remove or replace the Virtual Chassis module, follow
the instructions in “Removing a Virtual Chassis Module from a J-EX4500 Switch” on
page 133.
Related
Documentation
Rear Panel of a J-EX4500 Switch on page 9
•
30
Dell PowerConnect J-Series J-EX4500 Ethernet Switch Hardware Guide