Dell PowerConnect J-EX4500, Hardware Manual

Page: 111 / 226

Figure 38: Installing the Virtual Chassis Module in a J-EX4500 Switch
g021034
Related
Documentation
Removing a Virtual Chassis Module from a J-EX4500 Switch on page 133
•
•
Installing and Removing J-EX4500 Switch Hardware Components on page 87
Connecting a Virtual Chassis Cable to a J-EX4500 Switch
The Virtual Chassis module has two dedicated Virtual Chassis ports (VCPs) that can be
used to interconnect the J-EX4500 switch with J-EX4200 switches or with another
J-EX4500 switch to form a Virtual Chassis. The Virtual Chassis module is installed on
the rear side of the switch chassis. Use the procedure described in this topic to connect
a Virtual Chassis cable to a dedicated VCP port on a Virtual Chassis module.
Ensure that you have the following parts and tools available:
•
Phillips (+) screwdriver, number 2
NOTE: Virtual Chassis cables and cable connector retainers are not part of
the J-EX4500 switch shipping configuration and must be purchased
separately.
To connect a Virtual Chassis cable to a dedicated VCP on a J-EX4500 switch (see Figure
39 on page 96) :
1.
Taking care not to touch module components, pins, leads, or solder connections,
remove the Virtual Chassis cable from its bag.
2.
Using both hands, place the Virtual Chassis cable connector in the empty VCP and
slide it in gently until it is fully seated.
3.
Slide the cable connector retainer over the Virtual Chassis cable connector.
4.
Tighten the screws on the cable connector retainer by using the screwdriver.
95
Chapter 10: Installing Switch Components