Dell PowerConnect J-EX4500, Hardware Manual

Page: 150 / 226

3.
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
point on the chassis.
4.
Remove the fan tray from the switch. See “Removing a Fan Tray from a J-EX4500
Switch” on page 130.
5.
Loosen the captive screws on the front faceplate of the module using the screwdriver.
6.
Position your fingers under the module as shown in Figure 57 on page 134 and pull
outwards to unseat and eject the module.
NOTE: Do not use the captive screws to pull the module out from the
chassis. Pull from underneath the front edge of the module.
7.
Using both hands, gently slide the Virtual Chassis module halfway out of the chassis.
8.
Place one hand under the module to support it and slide it completely out of the
chassis.
9.
Place the Virtual Chassis module in an antistatic bag or on an antistatic mat placed
on a flat, stable surface.
Promptly install the replacement Virtual Chassis module. See “Installing a Virtual Chassis
Module in a J-EX4500 Switch” on page 93.
Figure 57: Removing the Virtual Chassis Module from a J-EX4500 Switch
Related
Documentation
Installing a Virtual Chassis Module in a J-EX4500 Switch on page 93
•
•
Installing and Removing J-EX4500 Switch Hardware Components on page 87
134
Dell PowerConnect J-Series J-EX4500 Ethernet Switch Hardware Guide