Dell PowerConnect J-EX4500, Hardware Manual

Page: 127 / 226

CHAPTER 12
Performing Initial Configuration
• J-EX4500 Default Configuration on page 111
• Connecting and Configuring a J-EX Series Switch (CLI Procedure) on page 117
•
Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 118
J-EX4500 Default Configuration
Each J-EX Series switch is programmed with a factory default configuration that contains
the values set for each configuration parameter when a switch is shipped. The default
configuration file sets values for system parameters such as
syslog and commit , configures
Ethernet switching on all interfaces, enables IGMP snooping, and enables the LLDP and
RSTP protocols.
NOTE: Interfaces
xe-0/0/0
through
xe-0/0/39
are the network interface
ports. Optional uplink modules provide four 10-gigabit small form-factor
pluggable (SFP+) transceivers (
xe-0/1/0
through
xe-0/1/3
) or four 1-gigabit
small form-factor pluggable (SFP) transceivers (
xe-0/2/0
through
xe-0/2/3
).
Although you can install only one uplink module, the interfaces for both are
shown below.
When you commit changes to the configuration, a new configuration file is created, which
becomes the active configuration. You can always revert to the factory default
configuration. See the
Dell PowerConnect J-Series Ethernet Switch Complete Software
Guide for Junos OS at
http://www.support.dell.com/manuals
.
This topic shows the factory default configuration file of a J-EX4500 switch:
system {
syslog {
user * {
any emergency;
}
file messages {
any notice;
authorization info;
}
file interactive-commands {
interactive-commands any;
111