Dell PowerConnect J-EX4500, Hardware Manual

Page: 119 / 226

5.
Insert the coupler end of the jumper cable or power cord into the AC appliance inlet.
6.
Push the retainer clip toward the cord until the cord slides into the slot in the
adjustment nut. Turn the nut until it is tight against the base of the coupler and the
slot in the nut is turned 90° from the top of the switch. See Figure 43 on page 103.
7.
If the AC power source outlet has a power switch, set it to the OFF (0) position.
8.
Insert the jumper cable or power cord plug into an AC power source outlet.
9.
If the AC power source outlet has a power switch, set it to the ON (|) position.
10.
Verify that the LED on the power supply faceplate is lit and is on steadily.
11.
Repeat Steps 2 through 10 for a second power supply, if needed.
Figure 43: Connecting the Power Supply Cord to a J-EX4500 Switch
g020943
Tighten
adjustment
nut.
Retainer
clip
Adjustment
nut
Related
Documentation
AC Power Supply in J-EX4500 Switches on page 21
•
•
AC Power Supply LEDs in J-EX4500 Switches on page 23
Connecting a J-EX Series Switch to a Network for Out-of-Band Management
You can monitor and manage a J-EX Series switch using a dedicated management
channel. J-EX Series switches have a management port with an RJ-45 connector for
out-of-band management. Use the management port to connect the J-EX Series switch
to the management device.
Ensure that you have an Ethernet cable with an RJ-45 connector available. One such
cable is provided with the switch. Figure 44 on page 103 shows the RJ-45 connector of
the Ethernet cable supplied with the switch.
Figure 44: Ethernet Cable Connector
To connect a J-EX Series switch to a network for out-of-band management (see Figure
45 on page 104):
1.
Connect one end of the Ethernet cable to the management port (labeled
MGMT
) on
the J-EX Series switch.
For the location of the
MGMT
port, see “Front Panel of a J-EX4500 Switch” on page 8
103
Chapter 11: Connecting the Switch