Datalogic AV7000, Reference Manual

Page: 76 / 337

AV7000 LINEAR CAMERA REFERENCE MANUAL
64
3
3.10 CBX100/CBX500/CBX800 CONNECTION BOX INITIAL
CONFIGURATION
Complete installation information on these connection boxes is available in the
CBX100,
CBX500, and CBX800 Installation Manuals available at www.datalogic.com .
CBX100
Please verify that the CBX100 connection box is configured for the AV7000 application as
follows:
Figure 63: CBX100 Initial Setup
Reference the image and diagram above:
1. Set RS422HD TERM switch to OFF.
2. Set POWER SUPPLY jumper to FROM DEVICE.
3. Insert jumper wire in pin block from REF to ID+ (one jumper in either block is
sufficient).
NOTE:
In order for a standalone or Master AV7000 to initialize properly, it
must be connected to a CBX100. On power-up the AV7000 looks for the
jumper (item number 3 in the image above) and will assume the responsibility
of providing the SYNC Network IP addresses. Slave units in an array/tunnel
will receive their SYNC Network IP addresses from the Master.
IMPORTANT:
Although multiple AV7000 cameras can have a CBX
box, only one of the CBX boxes in a multi-camera system can have
the Jumper to make it the Master.