Datalogic AV7000, Reference Manual

Page: 249 / 337

IMAGING FEATURES
237
5

Photoelectric Sensor, Trigger (if applicable)
Mount the photoelectric sensor according to the application drawing, and with the
following recommendations:

Make sure the PS is square to the conveyor

Make sure the PS is high enough off the conveyor surface that it will not get false triggers from
any part of the conveyor

Make sure the PS is aligned properly to the reflector. (In a sender receiver application, make
sure the two components are aligned correctly)

Make sure the PS is 155 mm [6 in] or greater upstream from the RangeFinder scan line (if
applicable).

If using the AS1 Area Sensor as trigger, see section 0 for information on installation and
alignment.
AV7000 Software Update
If necessary, a Datalogic technician will update the AV7000 CPU with the latest software.
This must only be done by, or under the guidance of, a trained Datalogic technician.
IMPORTANT:
DO NOT use a parameter file from any previous
AV7000 installations.
Connect a Laptop to the AV7000
The static and dynamic calibration can be accomplished using any of the three Ethernet
ports; Image, Host or Sync:

Host default IP: 192.168.3.10

Image default IP: 10.0.40.20

Sync Controller IP (the sync adapter cable must be used): 192.168.0.145
NOTE: Your PC’s IP address needs to match the camera
system’s IP Address range,
see section 4.1.2 for information on
connecting a laptop to the system.
NOTE:
The Host and Image port IP addresses may have been
changed for your application. Contact your system administrator
for changes.
Open a browser and enter cameras IP address into the browser’s address field. When
e-
Genius opens, enter the case sensitive user name (setup) and password (DLAset).