Datalogic AV7000, Reference Manual

Page: 61 / 337

ELECTRICAL INSTALLATION
49
3
3.2 CONNECTING AN AV7000 CAMERA
To install an AV7000, follow this sequence:
1. Complete mechanical installation
(See Chapter 2 .)
2. Complete electrical installation
(See wiring illustrations provided in this chapter.)
3. Observe all electrical safety requirements outlined in this chapter.
4. Ground the mounting structure to protective earth (PE) ground.
5. If used, wire the photoelectric sensor (or other trigger) to the CBX connection box.
6. Wire the tachometer to the CBX connection box.
7. Wire serial ports to the CBX connection box if needed.
8. Connect the M12 end of the Ethe
rnet cable to the barcode reader’s HOST NET port and
network switch as required by your application.
9. Wire the Remote Display to the CBX connection box (if used).
10. Connect the AV7000 to its power supply.
11. Connect the power supply to the power source.
12. Setup / check camera operations
(See Chapter Error! Reference source not found. .)