Maintaining the printer
4-17
User’s Guide for Magna™ Platinum Series™ Printers
7
Remove the ground cable connector from the ground tab of the swing arm by
pulling on the red sleeve (see
Figure 4-18
).
Figure 4-18: Printhead ground cable
♦
Replace the printhead cartridge
1
Carefully align the openings on the (white) power cable plug with the wires of the
power receptacle on the printhead. Push the cable’s plug all the way onto the
receptacle (see
Figure 4-17
).
2
Push the (gray) data cable plug into the new printhead cartridge (see
Figure 4-17
). Make sure the locking tabs are in place.
Do not press on the wires of the printhead cables.
3
If the printhead has a ground cable, slide the ground cable connector onto the
ground tab of the swing arm (see
Figure 4-18
).
4
Align the printhead cartridge pins with the printhead cartridge slots on the swing
arm (see
Figure 4-19
).
5
Slide the new printhead cartridge onto the swing arm, so the pins slide into the
slots (see
Figure 4-19
).
Figure 4-19: Align pins with slots on the swing arm
!
1
1
Summary of Contents for ImageCard Magna
