DataCard ImageCard Magna, User Manual

Page: 65 / 180

Maintaining the printer
4-11
User’s Guide for Magna™ Platinum Series™ Printers
Clean the supply tracker
1 Power off the printer.
The heated roller in the overlay or topcoat module operates at 400° F (200°
C). Wait 30 minutes or until the heated roller area is cool.
2 Lift the top cover.
If your printer has a locking cover, unlock the cover before opening it.
3 Prepare a printer cleaning card.
– If you just used a printer cleaning card in the printer, you can use that card to
complete this procedure.
– If you have not run a printer cleaning card, remove the protective paper from
one side of the card.
Figure 4-11: Remove the protective paper from the cleaning card
4 Lift the supply tracker until it stops and is held in place.
Remove the supply cartridge for easier access to the supply tracker. See
“Removing the supply cartridge” on page 2-7 for steps to follow.
5 Roll the sticky surface of the cleaning card against the supply tracker. Rotate the
supply tracker to clean all sides.
Do not touch the surface of the supply tracker with your fingers. Oils from the skin
can cause the supply tracker to slip or can affect card quality.
Figure 4-12: Clean the supply tracker
!
E
E
!