DataCard ImageCard Magna, User Manual

Page: 113 / 180

Install the printer
7-9
User’s Guide for Magna™ Platinum™ Series Printers
Connect the power cord
1 Attach the power cord to the power receptacle on the back of the printer (step 1 in
Figure 7-9 ).
Figure 7-9: Connect the power cord
2 Plug the other end of the power cord into a single-phase, 3-wire grounded
receptacle with 90-130V AC or 195-254V AC at 50 or 60 Hz (step 2 in
Figure 7-9 ).
The printer power supply automatically adjusts to the voltage of the input power.
3 Do not power on the printer until supplies are loaded.
♦
Preparing the printer for driver installation
After connecting the printer and PC and before installing the driver, do the following:
•
Load cards in the card cartridge. See “Loading cards” on page 2-3 .
•
Install the continuous cleaning roller in the printer. See “Replacing the cleaning
roller sleeve” on page 4-3 . There is no used sleeve to remove.
•
Install the print ribbon. See “Loading the print ribbon” on page 2-5 . When installing
a new printer, there is no used ribbon to remove.
•
If the printer includes an optional topcoat or overlay module, install the supply
material. See
“Loading the overlay or topcoat material” on page 2-7 .
•
Power on the printer and PC. See “Powering on the printer and PC” on page 2-13 .
•
The topcoat or overlay (laminator) module must warm up before printing a card. If
you complete driver installation and print the sample card before the laminator is
ready, a message box appears asking you to wait while the laminator warms up.
The card will complete processing as soon as all modules in the printer are ready.
1
2
i