DataCard ImageCard Magna, User Manual

Page: 26 / 180

2-8
Using the printer
User’s Guide for Magna™ Platinum Series™ Printers
Remove the supply cartridge
If the printer has a locking cover, unlock the cover before opening it.
1 Lift the top cover, as shown in Figure 2-5 .
The module is HOT to the touch and remains HOT for up to 30 minutes after
the printer is powered off.
2 Lift the supply tracker, and then push until it clicks into place (step 1 in
Figure 2-10 ).
Figure 2-10: Remove the supply cartridge
3 Pull out on the cartridge lock to release the supply cartridge (step 2 in
Figure 2-10 ).
4 Pull the supply cartridge out until the cartridge is out of the printer (step 3 in
Figure 2-10 ).
♦
Loading supply in the cartridge
After removing the supply cartridge from the printer, remove the used material and
load new material.
Load supply in the cartridge
1 Place the supply cartridge upside down on a level surface, such as a table, with
the wide side away from you.
2 Remove the spool caps (if used) from both spools.
3 Pull up firmly on the full take-up spool to remove it.
E
!
2
3
Supply tracker