Data I/O PSV5000, Owner'S Manual

Page: 131 / 176


The Laser Module and Shuttle

Laser Marking Fume Extractor
PSV5000 Owner’s Manual - 127 -
Perform the following procedure only if you have training regarding laser
etching processes or handling hazardous materials.
Wear safety goggles and disposable protective gloves..
For both these procedures contact Data I/O Customer Support or a local
Data I/O approved service representative.
R
EPLACING THE
F
UME
E
XTRACTOR
F
ILTERS
T
OOLS
R
EQUIRED
•
sealable plastic bag (approximately .06 M3 [2 cu. ft.])
•
protective gloves and goggles
• a particle (dust) mask
• access door key that came with your PSV5000
• UpperHand Fume Extractor Operation Manual
To replace the Fume Extractor Filters:
1. Properly shut off the PSV5000 sub-systems and machine power. See
Shutting Down the PSV5000 System on page 38.
WARNING: Possible health hazard! Lased materials can
contain hazardous toxins in the dust that cause eye and skin damage! DO
NOT use compressed air to remove laser dust or any method that allows the
particulate to be released into the work environment.
Some device material may be carcinogenic.
Wear safety goggles and disposable protective gloves.
WARNING: Health hazard! Failure to replace the laser vacuum filters
at the required intervals could create a hazardous operating environment.
2. Wear eye protection and put on disposable protective gloves.
3. Open the front access door.