![background image](http://html1.mh-extra.com/html/daikin/super-multi-nx-c-series/super-multi-nx-c-series_service-manual_3794977072.webp)
SiE12-411
Printed Circuit Board Connector Wiring Diagram
Printed Circuit Board Connector Wiring Diagram
61
1.2
Wall Mounted Type 50 / 60 / 71 Class
Connectors
Note:
Other designations
1) S1
Connector for fan motor
2) S6
Connector for swing motor (horizontal blades)
3) S8
Connector for swing motor (vertical blades)
4) S21
Connector for centralized control (HA)
5) S26, S37
Connector for buzzer PCB
6) S27, S29, S36
Connector for control PCB
7) S28
Connector for signal receiver PCB
8) S32
Connector for heat exchanger thermistor
9) S35
Connector for Intelligent Eye sensor PCB
10)S38
Connector for display PCB
1) V1
Varistor
2) JA
Address setting jumper
JB
Fan speed setting when compressor is OFF on thermostat
JC
Power failure recovery function
∗
Refer to page 257 for detail.
3) SW1
Forced operation ON/OFF switch
4) LED1
LED for operation (green)
5) LED2
LED for timer (yellow)
6) LED3
LED for Home Leave operation (red)
7) FU1
Fuse (3.15A)
8) RTH1
Room temperature thermistor
Summary of Contents for Super Multi NX C-Series
