Part
3. Commissioning Procedure
DCM014A51
Design Guide
121
3. Select "Internet Protocol (TCP / IPv4)" [1] and click the Properties button [2]. The "Internet
Protocol (TCP / IPv4) Properties" dialog box opens. This dialog box shows the test operation
PC's current IP address [3], subnet mask [4], and default gateway address [5].
4. Change the test operation PC's IP address.
Note: Use one of the following IP address depending on the current status of the
iTM
.
1. If the
iTM’s
IP address has not been changed from the factory setting, use the following
for the test PC:
• IP address: 192.168.0.2
• Subnet mask: 255.255.255.0
• Default gateway address: 192.168.0.100
2. If the iTM’s IP address
has been changed from the factory setting at the site
, use the
following:
• IP address shown in the table in
"[6]-2 IP address temporarily used for the test
service operation"
on P.87.
5. Enter the information above in "IP address" [3], "subnet mask" [4], and "default gateway" [5] in
the dialog box 2 of Step 1-3, and press the OK button [6]. The dialog box 1 reappears. Click the
OK button [7].
6. Reboot the PC. (Reboot may not be necessary depending on the Windows version. Reboot the
PC only when requested.)
5.4 Return the IP address of the test PC to the original address after the test operation.
(Be sure to return the test operation PC's IP address to the original setting.)
1. Return the test operation PC's IP address to the original setting.
1
2
7
3
4
5
6
