DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
300
sFlow Counter Poller Settings
This window is used to create the sflow counter poller settings on the Switch. Within the sflow counter poller function,
the port statistics counter information will be forwarded to the server at the configured interval. These counters are
RFC 2233 counters.
To view this window, click
Monitoring > sFlow > sFlow Counter Poller Settings
,
as shown below:
Figure 11- 25 sFlow Counter Poller Settings window
The following parameters can be configured:
Parameter Description
From Port /To Port
Specifies the port or list of ports to be configured.
Analyzer Server ID
(1-4)
The analyzer server id specifies the ID of a server analyzer where the packet will be
forwarded.
Interval (20-120)
Specifies the maximum number of seconds between successive statistic counter information.
To disable the interval tick the Disabled check box.
Click
Apply
to implement the changes made.
Ping Test
Ping is a small program that sends ICMP Echo packets to the IPv6 or IPv4 address you specify. The destination node
then responds to or "echoes" the packets sent from the Switch. This is very useful to verify connectivity between the
Switch and other nodes on the network.
To view this window, click
Monitoring > Ping Test
, as shown below:
Figure 11- 26 Ping Test window