DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
205
Parameter Description
Index
Choose the desired RADIUS server to configure:
1, 2
or
3
.
IPv4 Address/IPv6
Address
Select either IPv4 Address or IPv6 Address to set the RADIUS Server IP.
Authentication Port
(1-65535)
Set the RADIUS authentication server(s) UDP port. The default port is
1812
.
Accounting Port
(1-65535)
Set the RADIUS account server(s) UDP port. The default port is
1813
.
Timeout (1-255)
Enter the timeout value in seconds (
1
to
255
) the default value is
5
.
Retransmit (1-255)
Set the retransmit value in seconds (
1
to
255
) the default value is
2
.
Key
(Max:32 characters)
Set the key the same as that of the RADIUS server. Maximum length of the entry is 32
bytes.
Confirm Key
Re-enter the previously entered
Key
.
Click
Apply
to implement changes.
RADIUS Accounting Settings
The Accounting feature of the Switch uses a remote RADIUS server to collect information regarding events occurring
on the Switch. The following is a list of information that will be sent to the RADIUS server when an event triggers the
Switch to send these informational packets.
•
Account Session ID
•
Account Status Type
•
Account Terminate Cause
•
Account Authentication
•
Account Delay Time
•
Account Session Time
•
Username
•
Service Type
•
NAS IP Address
•
NAS Identifier
•
Calling Station ID
There are three types of Accounting that can be enabled on the Switch.
•
Network
– When enabled, the Switch will send informational packets to a remote RADIUS server when
network events occur on the Switch.
•
Shell
– When enabled, the Switch will send informational packets to a remote RADIUS server when a user
either logs in, logs out or times out on the Switch, using the console, Telnet, or SSH.
•
System
- When enabled, the Switch will send informational packets to a remote RADIUS server when system
events occur on the Switch, such as a system reset or system boot.
Remember, this feature will not work properly unless a RADIUS Server has first been configured. This RADIUS server
will format, store and manage the information collected here.
To view this window, click
Security > RADIUS > RADIUS Accounting Settings
,
as shown below:
