Document Number: 002-10635 Rev. *I
Page
303 of 325
S6J3310/20/30/40 Series
Page
Section
Change Results
177
9. Electric
Characteristics
9.1.2
Recommended
operating
condition
Error)
-
Correct)
Note:
−TA: Ambient temperature (JEDEC)
−TC: Case temperature (JEDEC), the maximum measured temperature of package case top.
−Both rating of TA and TC should simultaneously be satisfied as maximum operation temperature.
−The following condition should be satisfied in order to facilitate heat dissipation.
1. Four or more layers PCB should be used.
2. The area of PCB should be 114.3 mm x 76.2 mm or more, and the thickness should be 1.6 mm or
more. (JEDEC standard)
3. One layer of middle layers at least should be used for dedicated layer to radiate heat with residual
copper rate 90% or more. The layer can be used for system ground.
4. 35% or more of the die stage area which is exposed at back surface of package should be soldered to
a part of 1st layer.
5. The part of 1st layer should be connected to the dedicated heat radiation layer with more than 10
thermal via holes.
Example thermal via holes on PCB
<Figure>
− The above figure is a schematic diagram showing PCB in section.
− Thermal via holes should closely be placed and aligned with lands.
− It is recommended to connect the land pattern to the VSS-ground level (GND plan of inner layer bellow
the MCU) as thermal heat sink.
