Cyclades AlterPath ACS, Command Reference Manual

Page: 337 / 420

AlterPath ACS Command Reference Guide
321
Profile Configuration
Make sure that the physical connection between the ACS and the modems is
correct. The modem cable provided with the product should be used. Please see
Appendix C - Cabling and Hardware Information for pinout diagrams.
Step 4 - Confirm modem settings.
The ACS has been set for communication at 57600 bps, 8N1. The modems
should be programmed to operate at the same speed on the DTE interface.
Step 5 - Confirm routing.
Also make sure that the computer is configured to route console data to the serial
console port.
Step 6 - Perform a test dial-in.
Try to dial in to the ACS from a remote computer using the username and
password configured in step one. The computer dialing in must be configured to
receive its IP address from the remote access server (the ACS in this case) and to
use PAP authentication.
Step 7 - Activate changes.
Now continue on “Activate the changes.” on page 101 through “Save the
changes.” on page 102 listed in Chapter 4, “Network”.