Cyclades AlterPath ACS, Command Reference Manual

Page: 303 / 420

AlterPath ACS Command Reference Guide
287
PCMCIA Cards Integration
Edit the following parameter in the /etc/daemon.d/gendial.sh file to enable the
"automatically established" feature. The script restarts the dial-out function after a
reboot.
a) Set the parameter as described below.
ENABLE = YES
b) Save the gendial.sh configuration file by issuing the following command in
ACS.
[root@CAS root]# saveconf
Step 6 - To Activate the dial-out function, issue the following command.
Note: It is not necessary to reboot the ACS to activate the dial-out function. You can do this
by restarting the GDF daemon.
[root@CAS root]# daemon.sh restart GDF
A message similar to the following displays, confirming the GDF daemon restart.
[root@CAS root]# Sep 23 18:06:10 src_dev_log@CAS showlogmsg:
/bin/daemon.sh: CONFIG: Network daemon [generic-dial] started
The default route is not replaced in the static router table. The following message
displays.
[root@CAS root]# Sep 23 18:06:17 src_dev_log@CAS pppd[1028]: not replacing
existing default route to eth0 [172.20.0.1]
Step 7 - To change a static route or create a new one.
a) Edit the parameters in the /etc/network/st_routes file.
b) Activate the new routes by issuing the following command:
#> runconf
c) Save the new configuration to flash.
#> saveconf
d) Check the routes by issuing the following command.
#> route -n