Cyclades AlterPath ACS, Command Reference Manual

Page: 306 / 420

290
Profile Configuration
Parameter Description Factory Configuration
conf.dhcp_client It defines the dhcp client operation mode.
Valid values:
0 - DHCP disabled
1 - DHCP active
2 - DHCP active and the unit saves the last IP
assigned by the DHCP server in flash. 2
conf.eth_ip_alias Secondary IP address for the Ethernet interface (needed
for clustering feature).
Note: This parameter is inactive by default. To activate,
uncomment the parameter and set the desired value.
0
conf.eth_mask_alias Mask for the secondary IP address above.
Note: This parameter is inactive by default. To activate,
uncomment the parameter and set the desired value.
0
conf.rlogin It defines the location of rlogin utility
Note: This is a parameter specific to TS profile.
/usr/local/bin/rlogin-radius
conf.facility The local facility sent to syslog-ng from PortSlave. 7
conf.group Used to group users to simplify the configuration of the
parameter all.users later on. This parameter can be used
to define more than one group.
Note: This parameter is inactive by default. To activate,
uncomment the parameter and set the desired value.
0
conf.eth_ip Configured in Chapter 4. This is the IP address of the
Ethernet interface. This parameter, along with the next
two, is used by the
cy_ras program to OVERWRITE
the file /etc/network/ifcfg_eth0 as soon as the command
“ runconf ” is executed. The file /etc/network/ifcfg_eth0
should not be edited by the user unless the cy_ras
configuration is not going to be used.
Note: This parameter is inactive by default. To activate,
uncomment the parameter and set the desired value.
0 (IP address received
from DHCP Server)
Table 8.1: /etc/portslave/pslave.conf common parameters