Cyclades AlterPath ACS, Command Reference Manual

Page: 117 / 420

AlterPath ACS Command Reference Guide
101
Network
With the /etc/portslave/pslave.conf file opened search for the parameters
described below and change their values according to your necessities:
NOTE: To define a static IP address it is necessary to disable the DHCP client. Set to “zero”
the value of the following line:
conf.dhcp_client 0
Step 3 - Activate the changes.
Execute the following command to activate the changes:
# runconf
Step 4 - Test the configuration
Now you will want to make sure that the ports have been set up properly. Ping
the ACS from a remote machine. Using the Windows OS open a command
prompt window, type in the following, and then press Enter:
# ping <IP assigned to the ACS by DHCP or you>
An example would be:
# ping 192.168.160.10
If you receive a reply, your ACS connection is OK. If there is no reply see
Appendix C - Cabling and Hardware Information .
Step 5 - Telnet to the server connected to the first port of the ACS. (This will
only work if you selected
socket_server or socket_server_ssh as your all.protocol
parameter.)
While still in the DOS window, type the following and then press Enter:
# telnet <IP assigned to the ACS by DHCP or you> 7001
An example would be:
# telnet 192.168.160.10 7001
conf.eth_ip 192.168.100.1
conf.eth_mask 255.255.255.0
.
.
.
conf.dhcp_client 0
File Description 4.2: /etc/portslave/pslave.conf