CTE ZED 23.2 JH, Use And Maintenance Manual, Page: 41 / 56

Use and maintenance manual
ZED 23.2 JH
Code n°UM0260_GB
39
Replace the hydraulic oil filter, proceeding as follows (
fig. 6.5.10
) :
•
loosen the filter using the appropriate chain
wrench, if necessary
•
screw in the new filter by hand, taking care to
lubricate the sealing gasket using grease
•
top-up the hydraulic oil tank and control the level
through the indicator (
fig. 6.5.9
).
fig. 6.5.10
ATTENTION:
pay attention not to disperse hydraulic oil in the environment during
replacement. Dispose of the filter in compliance with the Law .
5.6.8 Restore work platform levelling
ATTENTION:
whenever you notice that the basket is not level with respect to horizontal,
lower the basket to the ground and descend from it.
DANGER:
the presence of persons in the basket during the operations is prohibited.
ATTENTION:
this maintenance must be carried out by a qualified technician (M).
Ripristinare la condizione di sicurezza
(cestello
orizzontale), operando come
segue:
•
Switch on the push-button panel
plugging it into the appropriate socket in
the frame
•
activate the jib lifting control lever (
pos. 2
fig. 6.1.1
), keeping the lever activated,
activate the speed regulation
potentiometric lever (
pos. 4 fig. 6.1.1
) until
the jib is in a horizontal position
•
ger to open the padlock on the diverter, remove the silver lever situated in the turret
by loosening the black locking knob. Turn both two-position diverters situated in the
rear of the extension cylinder by 90° to the levelling position (
fig. 6.1.3
)
•
descend from the deck and activate the “telescopic boom extension” control lever
(
pos. 3 fig. 6.1.1
) and without releasing it, activate the movement speeds control lever.
The basket can be levelled in this way (carry out a complete downward and upward
run with the basket and then align it) (
fig. 6.1.3
)
•
on completion of the operations, take the two position diverters situated at the base of
the extendable boom to the original position (extension position, indicated by the
sticker)
(
fig. 6.1.2
) , , remove the lever from the diverters and put it in position in the
fig. 6.1.1
3
4
2