CTE ZED 23.2 JH, Use And Maintenance Manual, Page: 33 / 56

Use and maintenance manual
ZED 23.2 JH
Code n°UM0260_GB
31
4.4 Emergency manoeuvres
4.4.1 Work platform emergency stop
The platform is equipped with an immediate emergency stop device for all
movements. To activate it just push the red mushroom-shaped emergency button,
whose position is indicated in
chap. 2.10.1
. Once the emergency has been dealt with,
normal functioning can be restored by rotating the button one quarter of a turn.
4.4.2 Work platform levelling
ATTENTION:
if the operator platform has pressed the emergency stop button, the
recovery is only possible by performing the maneuver described in
paragraph 4.4.5.
4.4.4 Recovering the work platform in the case of power failure
In case of malfunctioning in the vehicle engine or the gear pump that provides driving
power to the whole equipment, the working platform can be returned to the resting
position as follows:
•
remove the manual pump control lever fixed in the turret, by releasing the black
blocking knob
ATTENTION:
whenever you notice that the basket is not level with respect to
horizontal, lower the basket to the ground and descend from it.
Restore the safe condition (horizontal basket), operating as indicated in the
maintenance chapter, by a qualified technician (M). (
chap. 5.6.8
).
4.4.3 Recovering the basket from the ground if the operator faints
If the platform operator faints, is injured or otherwise unable to act, it is necessary to
operate the emergency ground controls as follows :
fig. 4.4.1
•
remove the cover of the plug for the portable push-
button panel located beside the ground control
panel.
•
switch on the push-button panel plugging it in.
•
insert the key into the selector switch and turn it to
the “Emergency controls" position (
pos. 2 fig. 4.4.1
).
•
activate the control switch required to make the
desired movement and activate the speed
regulation potentiometric lever simultaneously.
Activating the movement control switches with
caution, bring the work platform back to the rest
position.
•
when the operations have been completed , take
the key back to the “Basket controls” position (
pos.
1 fig. 4.4.1
).
•
remove the key and close the lid.
1
2