CTE ZED 23.2 JH, Use And Maintenance Manual, Page: 17 / 56

Use and maintenance manual
ZED 23.2 JH
Code n°UM0260_GB
15
2.11 Description of the controls
2.11.1 Control board on the ground
1. Right rear outrigger and minimum
stabilisation control.
2. Right front outrigger and minimum
stabilisation control.
3. Left rear outrigger and minimum
stabilisation control.
4. Left front outrigger and minimum
stabilisation control.
5. Voltage presence LED.
6. "Outriggers controls/neutral/basket
controls" key selector switch.
7. Emergency stop - by pressing the
emergency stop all machine
controls are deactivated and the vehicle engine switches off.
8. Error indicator light: the number of blinks indicates an error code (please contact
the Service centre).
9. Rear right stabiliser indicator light and ground contact control.
10. Front right stabiliser indicator light and ground contact control.
11. Rear left stabiliser indicator light and ground contact control.
12. Front left stabiliser indicator light and ground contact control.
ATTENTION:
the outrigger LEDs switch on when the plate has reached the minimum
extension and is in contact with the ground but they do not indicate
the correct stabilisation. Check correct positioning using a spirit level.
2.11.2 Control board in work platform
fig. 2.11.2
1. Work platform centre LED – switch-on indicates the correct centring of the work
platform. It must always be on when the work platform is centred. If the work
platform is not centred the LED switches off and an acoustic signal is activated.
2. Power supply presence LED – switches on in the presence of voltage.
3. Engine start/stop lever - upwards starts the engine, downwards stops it.
4. Overload LED - it switches on when the basket is loaded over the nominal capacity
(an acoustic signal is activated simultaneously).
fig. 2.11.1
3
5 2 1
4
7
6
1 4 9 8 7 6 5 2
3 11
10
8
9 10
11 12