CTE ZED 23.2 JH, Use And Maintenance Manual, Page: 23 / 56

Use and maintenance manual
ZED 23.2 JH
Code n°UM0260_GB
21
•
It is prohibited to use the machine in dangerous environments or where
inflammable or explosive materials or gases are present or in areas with an
explosive atmosphere.
•
Do not start the motor id there is an odour or traces of gas, petrol. oil or other
explosive substances.
•
It is prohibited to use the machine if environmental lighting cannot guarantee
sufficient visibility to perform the jobs or move in safe conditions.
•
Do not use the machine as a game.
3.3.6 DANGERS RELATIVE TO THE MACHINE
•
Carry out an in-depth pre-operational control of the machine and perform tests on
all functions before every shift.
•
Apply signs and place immediately out of service if controls malfunction of there
are safety device faults. It is prohibited to use a damaged or faulty machine.
•
Do not use the machine in the presence of hydraulic oil or air leaks. Hydraulic oil
or air can cause injury to the skin and burns.
•
Make sure that all controls relative to maintenance have been performed, as
specified in this manual.
•
Make sure that all stickers are present and legible.
•
Make sure that the operator instructions manual is integral, legible and put back
into the appropriate compartment in the cab.
3.4 Summary table of Standards for the operator
INSTRUCTION RULES
FOR THE OPERATOR
1 - The equipment can only be used by trained staff in charge.
2 - Never exceed the maximum capacity accepted.
3 - It is mandatory to use the safety belts and the helmet on the platform.
4 - The use and maintenance instructions supplied by the manufacture must be respected.
5 - Accident-prevention Standards in force must be respected during work on the platform.
6 - Do not use the platform whose functioning results abnormal.
7 - Before use, check the efficiency of the safety devices.
8 - Level the truck perfectly using the supplied outriggers.
The outriggers must be extracted completely and positioned in a way to discharge the
suspensions of the truck.
9 - Do not use the machine on weak or loose ground. Avoid inclines or land susceptible
to compromising the stability of the platform.
10- It is prohibited to move the truck with the platform lifted.
11- It is prohibited to work at distances less than 5 metres from bare electrical lines.
12- It is prohibited to anchor cables, cords or other to the platform.
13- It is prohibited to fix ladders, stools or other inside the platform to increase the work height.
14- Operate all controls in a smooth regular manner.
Never invert movements abruptly, always stop in correspondence with the neutral position.
15- Before making any movement, check that there are no obstacles and
no persons are in the trajectory.
THE COMPANY DOES NOT ASSUME ANY LIABILITY IF THE REGULATIONS STATED
ABOVE ARE NOT COMPLIED WITH