119
CHAPTER 3
INTRODUCTION TO CLI
3.9.28.3 (config)# loop-protect transmit-time
Syntax:
(config)# loop-protect transmit-time <t>
Explanation:
Configure the interval between each loop protection PDU sent on each port.
Parameters:
<t: 1-10>:
Specify a transmit time value. The valid values are from 1 to 10 seconds.
Example:
Set the transmit time value to 5 seconds.
Negation:
(config)# no loop-protect transmit-time
Show: #
show loop-protect [ interface ( <port_type> [ <plist> ] ) ]
3.9.28.4 (config-if)# loop-protect
Syntax:
(config-if)# loop-protect
Explanation:
Enable loop protection function on this interface.
Negation:
(config-if)# no loop-protect
Show: #
show loop-protect [ interface ( <port_type> [ <plist> ] ) ]
3.9.28.5 (config-if)# loop-protect action
Syntax:
(config-if)# loop-protect action { [ shutdown ] [ log ] }
Explanation:
Configure the action taken when loops are detected on a port.
Parameters:
{ [ shutdown ] [ log ] }: When a loop is detected on a port, the loop protection will immediately take appropriate
actions. Actions will be taken include “Shutdown Port”, “Shutdown Port and Log” or “Log Only”.
Negation:
(config-if)# no loop-protect action
Show: #
show loop-protect [ interface ( <port_type> [ <plist> ] ) ]
3.9.28.6 (config-if)# loop-protect tx-mode
Syntax:
(config-if)# loop-protect tx-mode
Explanation:
Enable a port to actively generate loop protection PDUs.
Negation:
(config-if)# no loop-protect tx-mode
# config t
(config)# loop-protect transmit-time 5
Summary of Contents for MSW-4424C Series
Page 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Page 382: ......
