52
CHAPTER 3
INTRODUCTION TO CLI
3.9.8.2 (config)# dot1x re-authentication
Syntax:
(config)# dot1x re-authentication
Explanation:
Set clients to be re-authenticated after an interval set in "Re-authenticate" field. Re-autentication can be
used to detect if a new device is attached to a switch port.
Example:
Enable re-authentication function.
Negation:
(config)# no dot1x re-authentication
Show:
> show dot1x status [ interface ( <port_type> [ <v_port_type_list> ] ) ] [ brief ]
# show dot1x status [ interface ( <port_type> [ <v_port_type_list> ] ) ] [ brief ]
3.9.8.3 (config)# dot1x authentication timer re-authenticate
Syntax:
(config)# dot1x authentication timer re-authenticate <1-3600>
Explanation:
Specify the time interval for a connected device to be re-authenticated. By default, the re-authenticated
period is set to 3600 seconds. The allowed range is 1 - 3600 seconds.
Parameters:
<1-3600>: Specify a re-authentication value between 1 and 3600.
Example:
Set re-authentication timer to 100.
Negation:
(config)# no dot1x authentication timer re-authenticate
3.9.8.4 (config)# dot1x timeout tx-period
Syntax:
(config)# dot1x timeout tx-period <v_1_to_65535>
Explanation:
Specify the time that the switch waits for a supplicant response during an authentication session before
transmitting a Request Identify EAPOL packet. By default, it is set to 30 seconds.
Parameters:
<v_1_to_65535>: Specify a timeout value between 1 and 65535 (seconds).
Example:
Set EAPOL timeout to 30 seconds.
# config t
(config)# dot1x authentication timer re-authenticate 100
# config t
(config)# dot1x re-authentication
Summary of Contents for MSW-4424C Series
Page 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Page 382: ......
