53
CHAPTER 3
INTRODUCTION TO CLI
Negation:
(config)# no dot1x timeout tx-period
3.9.8.5 (config)#dot1x authentication timer inactivity
Syntax:
(config)# dot1x authentication timer inactivity <10-1000000>
Explanation:
Specify the period that is used to age out a client’s allowed access to the switch via 802.1X and MAC-
based authentication. The default period is 300 seconds. The allowed range is 10 - 1000000 seconds.
Parameters:
<10-1000000>: Specify a value between 10 and 1000000 (seconds).
Example:
Set the aging time to 300 seconds.
Negation:
(config)# no dot1x authentication timer inactivity
3.9.8.6 (config)# dot1x timeout quiet-period
Syntax:
(config)# dot1x timeout quiet-period <v_10_to_1000000>
Explanation:
The time after an EAP Failure indication or RADIUS timeout that a client is not allowed access. This
setting applies to ports running Single 802.1X, Multi 802.1X, or MAC-based authentication. By default, hold time is set
to 10 seconds. The allowed range is 10 - 1000000 seconds.
Parameters:
<10-1000000>: Specify a value between 10 and 1000000 (seconds).
Example:
Set hold time to 30 seconds.
Negation:
(config)# no dot1x timeout quiet-period
3.9.8.7 (config)# dot1x feature
Syntax:
(config)# dot1x feature { [ guest-vlan ] [ radius-qos ] [ radius-vlan ] }
Explanation:
Enable the specified feature.
# config t
(config)# dot1x timeout quiet-period 30
# config t
(config)# dot1x authentication timer inactivity 300
# config t
(config)# dot1x timeout tx-period 30
Summary of Contents for MSW-4424C Series
Page 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Page 382: ......
