200
CHAPTER 3
INTRODUCTION TO CLI
3.9.52.5 (config)# voice vlan vid
Syntax:
(config)# voice vlan vid <vid>
Explanation:
Set voice VLAN ID.
Parameters:
<vid>: Specify voice VLAN ID.
Negation:
(config)# no voice vlan vid
Show:
# show voice vlan [ oui <oui> | interface ( <port_type> [ <port_list> ] ) ]
3.9.53 (config)# web privilege group
Syntax:
(config)# web privilege group <group_name> level { [ cro <cro> ] [ crw <crw> ] [ sro <sro> ] [ srw <srw> ] }*1
Explanation:
Assign Aggregation group to crw (configuration/excute read-write) level 15.
Parameters:
group <group_name>: This name identifies the privilege group. Valid words are 'Aggregation' 'DHCP' 'Debug'
'Dhcp_Client' 'Diagnostics' 'EPS' 'ERPS' 'ETH_LINK_OAM' 'EVC' 'IP2''IPMC_Snooping' 'LACP' 'LLDP' 'Loop_Protect'
'MAC_Table' 'MEP' 'MVR' 'Maintenance' 'Mirroring' 'NTP' 'POE' 'PTP' 'Ports''Private_VLANs' 'QoS' 'RPC' 'Security'
'Spanning_Tree' 'System' 'Timer' 'UPnP' 'VCL' 'VLAN_Translation' 'VLANs' 'Voice_VLAN'.
level { [ cro <cro: 0-15> ] [ crw <crw: 0-15> ] [ sro <sro: 0-15> ] [ srw <srw: 0-15> ] }*1: Every group has an
authorization Privilege level for the following sub groups:
cro (configuration read-only): The privilege level is 1 to 15.
crw (configuration/execute read-write): The privilege level is 1 to 15.
sro (status/statistics read-only): The privilege level is 1 to 15.
srw (status/statistics read-write): The privilege level is 1 to 15.
User Privilege should be the same or greater than the authorization Privilege level to have access to that group.
Example:
Set Voice VLAN to VID 1000.
Negation:
(config)# no web privilege group <group_name> level
Show:
> show web privilege group <group_name> level
# show web privilege group <group_name> level
# config t
(config)# web privilege group aggregation level crw 15
Summary of Contents for MSW-4424C Series
Page 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Page 382: ......
