thecrowgroup.com
Page | 37
Radio Supervise Alarm Beeps
Keypads
If a zone is programmed as a radio zone and that
type is actively monitoring the supervision signal, a
supervise signal failure from the detector alarm
can sound the buzzer at selected Keypads for local
alarm signaling
disable
Zone Sensor-watch Alarm
Beeps Keypads
If the zone is programmed for inactivity monitoring
and it is not operated within the time set at a
'Sensor-watch' alarm will be generated. A 'Sensor-
watch' failure from the detector can sound the
buzzer at selected Keypads for local alarm signaling
disable
Armed zone entry delay beeps
to keypads
If the alarm is Armed and a delay zone triggers the
entry delay it can also beep the keypad buzzer to
warn that the entry delay is counting down and the
alarm should be turned off
disable
Stay mode entry delay beeps to
keypads
If Stay Mode is Armed and a Stay Mode delay zone
triggers the entry delay it can also beep the keypad
buzzer to warn that the entry delay is counting
down and the alarm should be turned off
disable
Outputs
Settings
Parameter
Description
Default Configuration
Lockout Output
This option is used to limit the output to one
operation per arming period.
disable
Pulse Output on Kiss-off after
Arming
This option will cause the Output to short single
pulse when any area is armed and the message has
been kissed off by monitoring company.
disable
Disable Output During Disarm
This option will cause the Output to be disabled
when all areas in DISARM state. It is designed to
keep audible alarms silent when the full system
disarm, but part of alarms (like Panic or Fire alarm)
still turns audible alarms to on regardless of this
setting.
disable
Enable Monitoring of output
If this option is enabled, the control panel monitors
the status of the outputs by voltage level for wired
outputs or coming supervision messages for
wireless outputs. If disabled - monitoring the state
of the outputs will disabled
disable
Enable Mute
Disable the siren sound only
disable