![background image](http://html1.mh-extra.com/html/crary/cws-case-ih-2162/cws-case-ih-2162_owners-manual-and-parts-manual_2679353023.webp)
PN 50887-00
Case IH 2162/MacDon FD1, FD70, FD75 Crary Wind System Owner’s/Parts
15
4.3.1 SHORTENING THE DRIVELINE (OPTION A)
1. Pull the driveline into two pieces. Connect one end to
the combine and the other end to the drive shaft. Line
up the two halves parallel to each other.
2. Measure the distance from the end of one driveline tube
to the bottom of the end shield of the other driveline
half (dimension A in Figure 11). Measure and mark the
driveline tube 1-9/16” inward from dimension A.
3. Cut the shield tube in the marked position.
4. Using the cut piece of shield tube as your measurement,
place the cut piece against the end of the shaft. Mark
and cut the shaft.
5. Using the cut piece of shield tube as your measurement,
mark and cut the tube on the other half of the driveline,
and then the shaft.
6. File both shaft ends, and slide the two halves back
together.
4.3 DRIVELINE ADJUSTMENT
IMPORTANT
The driveline shields must be reinstalled to the original
equipment standards of construction and installation.
Figure 11: Shorten the driveline if it is too long
Figure 12: Removing the shield tube
4.3.2 SHORTENING THE DRIVELINE (OPTION B)
1. Using a Phillips screwdriver, remove the screw at the
flexible cone base of the outer shield tube. Then, twist
the flexible cone until the cone flare aligns with the
bearing tab (Figure 12). Pull the yoke and inner profile
out of the tubing.
2. Remove the spring pin.
3. Find a pipe that is large enough to slide the inner profile
inside, but is small enough that the end yoke will not
pass through. This pipe should extend at least 4 inches
past the end of the driveline inner profile.
A. Insert the inner profile into the pipe.
B. Place a steel plate on the floor and, with the
yoke pointing up, bounce the pipe on the steel
plate. After several bounces, the inner profile
should drop out of the yoke and onto the floor.
4. Cut the yoke end of both the shaft and shield tube by
the length determined.
5. Insert the profile back into the yoke and drill a new
spring pin hole.
6. Insert the spring pin.
7. Drill new holes in the shield to accept the shield bearing.
8. Install the driveline shield by reversing the disassembly
process from Step 1.
If you determined that your driveline needs to be shortened,
use the following steps to modify the shaft length.
If the amount required to be cut off does not include a grease
zerk use the steps in section 4.3.1. If a grease zerk is within
the cutting area, use the steps in section 4.3.2.
ASSEMBLY
Summary of Contents for CWS CASE IH 2162
Page 8: ...PN 50887 00 Case IH 2162 MacDon FD1 FD70 FD75 Crary Wind System Owner s Parts viii ...
Page 17: ...PN 50887 00 Case IH 2162 MacDon FD1 FD70 FD75 Crary Wind System Owner s Parts 9 ...
Page 58: ...PN 50887 00 Case IH 2162 MacDon FD1 FD70 FD75 Crary Wind System Owner s Parts 50 PARTS ...
Page 91: ......