![background image](http://html1.mh-extra.com/html/crary/cws-case-ih-2162/cws-case-ih-2162_owners-manual-and-parts-manual_2679353050.webp)
PN 50887-00
Case IH 2162/MacDon FD1, FD70, FD75 Crary Wind System Owner’s/Parts
42
OPERATION
5.6 OPERATING HINTS
The following are recommended adjustments the operator
can make based on crop conditions. Any adjustments that
involve the operator leaving the combine cab should heed
the warning instructions listed below.
1. Increase air to maximum.
2. Move tilt control until air is directed at back of sickle bar
with reel feeding properly.
3. Gradually reduce air until crop is no longer flowing
smoothly across sickle.
4. Gradually increase air until smooth crop flow across
the sickle is achieved.
5. Remember: more air uses more horsepower.
6. Gradually adjust air position fore and aft until optimum
crop flow is achieved.
7. Gradually reduce air further until minimum air is used
to maintain crop flow.
5.7 TRANSPORTING
The CWS is designed to be easily and conveniently moved
from location to location. When transporting the machine,
review and follow these safety instructions:
1. Make sure you are in compliance with all local regula-
tions regarding transporting equipment on public roads
and highways.
2. It is the responsibility to the owner to know the light-
ing and marking requirements of the local highway
authorities and to install and maintain the equipment
to provide compliance with the regulations. Add extra
lights when transporting at night or during periods of
limited visibility.
3. See the owner’s manual that came with your combine
and header for proper transportation guidelines.
DO USE AIR TO FEED CROP ACROSS THE SICKLE.
DO ADJUST AIR TUBE ANGLE TO MAXIMIZE CROP
FLOW ACROSS THE SICKLE.
DO USE THE REEL TO BRING THE CROP TO THE
HEADER.
DO MAKE ADJUSTMENTS GRADUALLY.
DO VERIFY PROPER AIR POSITION WHENEVER
ADJUSTING REEL HEIGHT OR FORE AND AFT
POSITION.
DO SHUT OFF AIR IMMEDIATELY IF THE AIR HOSE
SHOULD FAIL. FAILURE TO DO SO MAY RESULT
IN GEARBOX FAILURE.
DO FOLLOW TROUBLESHOOTING GUIDE ONE
STEP AT A TIME.
DO NOT USE MORE AIR THAN NEEDED.
DO NOT OPERATE WITH THE AIR TUBES ON THE
GROUND.
DO NOT OPERATE WITH PLUGGED AIR TUBES.
DO NOT OPERATE WITH AIR HOSE DISCON-
NECTED.
Place all controls in neutral or off , stop combine engine,
set parking brake, remove ignition key, wait for all
moving parts to stop, then properly block machine
before servicing, adjusting, repairing, or unplugging.
WARNING
Summary of Contents for CWS CASE IH 2162
Page 8: ...PN 50887 00 Case IH 2162 MacDon FD1 FD70 FD75 Crary Wind System Owner s Parts viii ...
Page 17: ...PN 50887 00 Case IH 2162 MacDon FD1 FD70 FD75 Crary Wind System Owner s Parts 9 ...
Page 58: ...PN 50887 00 Case IH 2162 MacDon FD1 FD70 FD75 Crary Wind System Owner s Parts 50 PARTS ...
Page 91: ......