Crary CWS CASE IH 2162, Owner'S Manual And Parts Manual, Page: 49 / 92

PN 50887-00 Case IH 2162/MacDon FD1, FD70, FD75 Crary Wind System Owner’s/Parts
41
OPERATION
PROGRAMMING INSTRUCTIONS :
Each transmitter has its own unique internal address that
is transmitted whenever a button is pressed. The receiver
needs to be programmed to respond only to transmitters it
is intended to operate with. The following steps confi gure
the receiver to operate with a particular transmitter(s). Up
to twelve transmitters can be programmed to one receiver.
Prior to programming the receiver, verify that the receiver
is connected to the input power. When the receiver enters
program mode, all previous transmitter addresses that were
programmed will be erased from the receiver's memory.
1. Locate the push-button labeled "PROGRAM" on the
receiver. Press and hold this button until the red LED
next to the program button illuminates (approximately
2 seconds). The receiver is now in the transmitter
program mode. Release the button. At this point all
previously programmed transmitter addresses are
erased from the receiver's memory.
2. Press and release any button on the transmitter and
verify that the red LED on the receiver extinguishes and
then illuminates (blinks once).
3. Repeat previous step for additional transmitters that
will operate with this particular receiver. The red LED
on the receiver will extinguish and illuminate one time
for the first transmitter being programmed, twice for
the second, three times for the third, four times for the
fourth etc. The receiver will not respond to transmitters
that have already been programmed.
4. After 5 seconds of no switch being pressed on
the transmitter(s) the receiver will return to normal
operation. The red LED on the receiver will blink
rapidly, then extinguish. The receiver is now in
the normal mode of operation. This completes the
programming instructions. The receiver will retain all of
its programming even when power is removed
Figure 52: Manifold tilt and fan air volume switch
FAN AIR VOLUME
SWITCH
MANIFOLD TILT
SWITCH
MANIFOLD TILT
SWITCH
Figure 53: Air fl ow
ADJUSTMENT STRAP
ARM MOUNT TUBE
REEL MOUNT
PIVOT CLAMP
CUTTER BAR
ELECTRIC
ACTUATOR
BUTTERFLY
FAN BUTTERFLY
ACTUATOR
INDICATOR
(SHOWN FULLY
OPEN POSITION)
INDICATOR
(FULLY CLOSED
POSITION)
Figure 54: Fan butter fl y actuator
5.5 CONTROLS
Before starting to work, all operators should familiarize
themselves with the location and function of the controls
and safety devices. Some machines may vary due to
diff erent models of combines and headers. Refer to Figure
52 through Figure 54.
MANIFOLD TILT:
1. Moving the toggle switch to the FORE position extends
the shaft of the electric actuator. This directs the air
tubes toward the back of the header.
2. Moving the toggle switch to the AFT position retracts the
shaft of the electric actuator. This directs the air tubes
toward the front of the header.
FAN AIR VOLUME ACTUATOR:
1. Move the toggle to the OPEN position to open the
butterfly plate which increases air volume to the air
tubes.
2. Move the toggle to the CLOSED position to close the
butterfly plate which decreases air volume to the air
tubes.
REEL LIFT/FORE AND AFT ADJUSTMENT:
Consult your owner/operator’s manual that came with your
header.
NOTE
This remote has been programmed from the factory and is
ready for use. The following programming instructions are
provided in the event you need to reprogram your remote.