Covidien Force FX, Service Manual

Page: 156 / 246

Inspecting the Generator
6-2
Force FX Electrosurgical Generator C Service Manual
Inspecting the Generator
If the generator malfunctions, check for obvious conditions that may have caused the
problem:
• Check the generator for visible signs of physical damage
• Verify that all accessory cords are properly connected
• Check the power cord. Replace the power cord if you find exposed wires, cracks,
frayed insulation, or a damaged connector
• Open the fuse drawer and inspect the fuse housing and fuses for damage and
corrosion. Verify that the fuses are firmly seated
An internal component malfunction in the generator can damage the fuses. You may
need to replace the fuses if the generator fails the self-test or stops functioning. Refer to
Fuse Replacement on page 7-13
.
Inspecting the Receptacles
Equipment required
• Bipolar footswitch
• Monopolar footswitch
• Bipolar instrument cords (handswitching and footswitching)
• Monopolar instrument cords (handswitching and footswitching)
1.
Turn off the generator.
2.
Disconnect the power cord from the wall receptacle.
3.
Check the three Footswitch receptacles on the rear panel for obstructions or damage.
Check for a secure fit by inserting the bipolar footswitch or monopolar footswitch
connector into the appropriate receptacle.
If any connection is loose, replace the Footswitch board assembly. Refer to
Footswitch
Board Replacement
on page 7-8
.
4.
Check the Bipolar Instrument receptacle on the front panel for obstructions or
damage. Insert the bipolar instrument connector (footswitching and handswitching)
into the appropriate receptacle to verify a secure fit.
If the connection is loose, replace the front panel. Refer to
Front Panel Replacement
on page 7-9
.
5.
Check the Monopolar 1/CEM and Monopolar 2 Instrument receptacles on the front
panel for obstructions or damage. Insert the monopolar instrument connector
(footswitching and handswitching) into the appropriate receptacle to verify a secure
fit.
If any of the connections are loose, replace the front panel. Refer to
Front Panel
Replacement
on page 7-9
.