Corghi WIND-TWIST, Operator'S Manual

Page: 41 / 136

WIND-TWIST operator’s manual 41
GB
machine from pneumatic and electric power supply, and check that all the moving
parts are locked in place.
ATTENTION
Do not remove or make changes to any part of this machine (only the assistance
service may do this).
- The regulator/lubricator fi lter is equipped with a semi-automatic condensate water
drain. This device is automatically activated whenever pneumatic supply to the ma-
chine is cut off. Drain manually when the level of condensate is too high.
- From time to time, lubricate the spindle carrier arm on the rotation axis.
- On a regular basis, when the machine is at a standstill, remove the back panels and
remove the fl uff that has collected there. Be careful not to pull out the electric wires.
Do not use compressed air to clean the machine, since this will spread the yarn fl uff
on the mechanical moving parts and the electronic components.
- Watch the oil level. If it has to be topped up, add only CORGHI Komol 220° oil or an
equivalent (refer to the chart on the machine). Before adding oil, clean off all the fl uff
from inside the head.
WARNING
Keep the work area clean
Do not clean the machine with compressed air or jets of water.
When cleaning the area take steps to avoid raising dust as far as possible
SCRAPPING
If the machine is to be scrapped, remove all electrical, electronic, and plastic compo-
nents and dispose of them separately, as provided for by local legislation.