Conair Carousel Plus D Series, User Manual

Page: 95 / 208

4
Opera
tion
S t o p p i n g t h e D r y e r
The DC-C Dryer control is programmed to follow a procedure for proper stopping the dryer.
Once the stop button has been pressed (or the Autostop time is reached), the heaters will be
turned off (RW hopper heaters, heater pack, or other hopper heater) and the dryer blower
will continue to run until the regen temperature reaches the factory set cooldown setpoint.
To stop the dryer:
1
Press the stop button on the dryer control.
The hopper heaters
will turn off immediately and the blower will continue to run until
the dryer reaches the cooldown setpoint.
2
Observe the dryer status changing to “Stopping” or “Shut-
down”.
3
Wait until the dryer status changes to “Standby” which will alert
you that the cooldown setpoint has been reached.
Depending on
your process temperature, this cooldown time could only take a few
seconds, or could take longer.
4
If you would like to shut down the dryer at this time, turn the ro-
tary disconnect switch to the OFF position.
ResinWorks configuration
Stand alone configuration
OFF
O
ON
I
IMPORTANT: Except in an emergency, aways wait until the dryer control dis-
plays “Standby” in the status display before turning the rotary disconnect to
the OFF position. Failure to do so will not allow the dryer to progress through
the cool-down procedure and could result in damage to your equipment.
O p e r a t i o n l 4 - 5 5