![background image](http://html1.mh-extra.com/html/conair/carousel-plus-d-series/carousel-plus-d-series_user-manual_2649057176.webp)
M o u n t i n g M e t h o d 3
( c o n t i n u e d )
6
Place the gasket over the probe hole.
7
Place the adapter plates over the gasket
and secure
them to the hopper with three
10-32 UNF screws. Make sure the
adapter plate with the threaded holes is on
the bottom, and that the slots in the
adapter plates are oriented in the opposite
direction as shown.
See drawing to right,
#7
.
8
Secure the coupling to the adapter
plates
with the four 10-32 UNF screws.
9
Screw the fitting into the coupling.
Tighten with a wrench.
10
Make sure the probe is the
correct size.
The probe should
extend from just above the top
of the hopper into the hopper,
with the tip approximately in-
line with the bottom edge of the
diffuser cone.
11
Push the compression sleeve into the
fitting.
12
Tighten the nut over the sleeve.
The
compression sleeve will crimp the tube to
hold the probe in place. Be sure to posi-
tion the connector in such a way as to
avoid interference of the cable with the
loader, etc. Use a wrench to tighten the
nut so that it covers the threads.
13
Thoroughly clean the inside of the hop-
per
to remove any debris left from installation of the probe.
Gasket
Sleeve
Connector
Coupling
Hopper
Nut
Fitting
Adapter
plate
Threaded
adapter plate
10
8
7
6
9
11
12
C - 1 4
l A p p e n d i x
Summary of Contents for Carousel Plus D Series
