![background image](http://html1.mh-extra.com/html/conair/carousel-plus-d-series/carousel-plus-d-series_user-manual_2649057174.webp)
M o u n t i n g M e t h o d 2
(Drying hopper with enough overhead clearance to
insert probe from the top of the hopper)
1
Reference the drawings at the end of this user guide
and select the drawing that
reflects your installation. Drill the appropriate hole in the top of the hopper.
2
Drill and tap four 10-32 UNF
holes
to match the hole pattern
in the coupling.
3
Secure the gasket and coupling to the hopper
with the four 10-32 screws.
Remove any excess gasket with a knife.
4
Insert the probe through the coupling
in the
top of the hopper.
5
Screw the fitting into the coupling.
Tighten
with a wrench.
6
Make sure the probe is the correct size.
The
probe should extend from just above the top of
the hopper into the hopper, with the tip approx-
imately in-line with the bottom
edge of the diffuser cone.
7
Push the compression sleeve into
the fitting.
8
Tighten the nut over the sleeve.
The compression sleeve will crimp the tube to
hold the probe in place. Be sure to position the
connector in such a way as to avoid interfer-
ence of the cable with the loader, etc. Use a
wrench to tighten the nut so that it covers the
threads.
9
Thoroughly clean the inside of the hopper
to
remove any debris left from installation of the
probe.
Four 10-32 UNF
holes evenly spaced
around a 1
1/
2
in.
(38.1 mm) circle
1/
2
in. (12.7 mm)
diameter center hole
Sleeve
Connector
Coupling
Gasket
Nut
Fitting
NOTE:
The mounting
adapter kit will only be
included if the DM was
ordered as a retrofit kit.
Remove the mounting adapter
plates from the probe assem-
bly, you will not need them.
You will need the gasket.
✐
IMPORTANT:
Stretch
cloth or plastic across
the inside of the hopper
to catch metal shavings
from the hole you will
drill in the top of the
hopper.
Tools for Installation:
❒
Drill and 10-32 tap
❒
Knife
❒
Flathead screwdriver
❒
7/8-in. wrench
NOTE:
If the angled probe is
used, the bend (dog leg) in the
probe must be oriented so that
it is angled in toward the center
of the hopper.
✐
2
8
7
5
3
6
CAUTION:
Always dis-
connect and lock out
the main power supply
before beginning the
installation process.
CAUTION: Hopper
surfaces may be hot.
Make sure the drying
hopper is empty and
has cooled to room
temperature before
installing the probe
assembly. Failure to do
so can lead to serious
injury.
C - 1 2
l A p p e n d i x
Summary of Contents for Carousel Plus D Series
