CombiSteel 7280.0070, Instruction Manual

Page: 18 / 81

35 34
EN
EN
Version with electromechanical controls
(optional dispensers)
Version with electronic controls,
LCD display (standard dispensers)
To correctly dose the amounts of detergent
and rinse aid follow the manufacturers‘
directions given on the packs, which vary
according to the type of dirt, water hardness
and tank capacity.
Insert the suction tubes of the dispensers,
equipped with ballast, in the detergent and
rinse aid containers (not supplied).
When changing the type of
detergent or rinse aid, drain
the tank and boiler completely,
connect the dispenser suction
pipes to a hot water tank and
run 3 washing cycles.
This operation is necessary in
order to prevent the products
from crystallising with possible
damage to the dispenser.
6. STARTUP, FIRST SWITCH-ON
The user must have sufficient knowledge and
experience in order to read and understand
the information in this manual, interpret
the signs and symbols on the machine, and
carry out safety operations (e.g. turn off
the main switch if water leaks are detected
inside the technical compartment or in case
of malfunction causing abnormal noise).
6.1 Controls and adjustments
For commissioning the dishwasher, carry
out the following checks:
- Make sure all the cover panels and safety
devices are fitted and efficient.
- Check the hydraulic connection and drain
connection (see paragraph 4.3).
- Check the electrical connections and that
the power supply matches that specified on
the data plate.
- Make sure there are no foreign objects
inside the washing chamber and tank.
6.2 First switch-on
Connect the power cable to the control
panel, activate it, and turn on the water
tap. If present, the detergent and rinse aid
dosing system must be adjusted according
to the water supply hardness and the type
of detergent and rinse aid used.
The adjustment operation will be necessary
even if a water softening system is installed
on the feed line. The dishwashers leave the
factory with dispensers adjusted to half
flow rate. To adjust the flow rate of the
dispensers, use the adjustment screw as
shown in the figure:
MAKE SURE THE OVERFLOW
AND THE PUMP FILTER
ARE PROPERLY FITTED
Internal view
of tank
MAKE SURE THE SURFACE
FILTERS ARE IN PLACE
Adjustable rinse aid
dispenser 0 ÷ 0,12 gr/sec
Adjustable detergent
dispenser 0 ÷ 0,82 gr/sec
Fixed detergent dispenser 0,82 gr/sec
time setting from control panel
Fixed rinse aid dispenser 0,12 gr/sec
time setting from control panel