CombiSteel 7280.0070, Instruction Manual

Page: 16 / 81

31 30
EN
EN
4. INSTALLATION
During installation, connection and startup,
strictly observe the following instructions.
The warewasher must be
installed by specialised
personnel, in compliance with
the safety regulations in force in
the place of use, and following
the instructions given below.
Always wear personal protective
equipment to carry out this type
of operation.
Failure to follow these
instructions will void the
manufacturer’s warranty on
functional performance and/or
damage to the machine.
If your warewasher is found to
be damaged when unpacked,
contact the dealer before
using it.
The machine must be taken to the place of
installation on the pallet supplied, using a
pallet truck or forklift.
The place must be a professional and not
domestic type, having industrial type wall
or floor drains with collection trap with
discharge of at least 3 l/sec.
Make sure the floor in the place of
installation is flat and can take the weight of
the machine full of water with rack loaded
with items (+40% of the net weight).
4.1 Storage
Before installation the machine can be
stored in a sheltered and dry place, with
temperatures between 5°C and 40°C.
For long idle periods it is advisable to
manually rotate the wash and rinse pump
impeller (PRS versions) to free it from
possible sticking.
4.2 Machine handling
The machine must be handled
by qualified personnel who have
adequate experience and training
regarding:
- the applicable safety
regulations;
- the ability to identify dangerous
situations and adopt the
appropriate behaviour.
The packed machine must be unloaded and
transported with a forklift truck, making
sure to engage the forks in the pallet
frontally.
Once on the ground, before being taken
to the place of installation, remove the
packaging, lift the machine with the forks
between the pallet and base, always in a
diagonal and rear position, remove the
pallet and position the machine.
Using a pallet truck (suitable for the weight
to be lifted - see net weight in the data
table), engage the forks under the base of
the machine, placing cardboard between
the pallet truck and the machine to avoid
damaging it.
Do not lift the machine too high from the
ground during transport and make sure the
route is flat and free of any obstructions.
Before moving the machine, check the size
of passage through the doors and the space
for handling operations.
To lift the warewasher safely
the pallet truck forks should
protrude at least 10 cm on the
opposite side of the base. Wear
protective gloves and safety
shoes before removing the
packaging.
4.3 Water connection
The connections must be carried
out by qualified personnel in
compliance with the laws in
force in the place of installation.
Make sure the water supply pressure is
between 100÷500 kPa dynamic (1÷5 Bar)
for version with atmospheric boiler, and
between 200÷500 kPa dynamic (2÷5 Bar) for
version with mains pressure boiler.
This measurement must be carried out
during the first water filling; if the pressure
is higher, install a pressure reducer upstream.
If the water has a high content of calcium
and magnesium salts, with hardness >20°f,
it is advisable to install a water softener.
Each machine is supplied with a water
filling rubber hose with a 3/4” connection
which must be connected to the mains
water supply.
The inlet water temperature
should be between 10°C and
50°C.
If the “ES” energy recovery unit or the
water softener “S” are installed, the inlet
water temperature must not exceed 25°C.
The drain pipe must be connected to
room’s main discharge; it is advisable to
interpose a floor drain trap. In the version
with incorporated drain pump (option),
the drain pipe already has an internal trap
(max. discharge H 800 mm).
INTERPOSE A PIECE OF
PROTECTIVE CARDBOARD
MIN 10 cm