Collamat Etiprint Inline, Operating Instructions Manual

Page: 92 / 188

2 Safety advices
2.1
Important warnings
Before installing and operating the
Collamat
8600/9100read the following
safety instructions.
The monitor C8600/C9100 is exclusively intended to control the labeller
C8600/C9100.
Install the labeller C8600/C9100 only by a trained specialist considering the
national specific regulations of
prevention of accidents
construction of electrical and mechanical systems
noise suppression (RMI)
Take notice of the technical data of the Collamat 8600/9100. Especially the
environment conditions must be observed.
Install the Collamat 8600/9100 at a dry location, protected from splashing water.
Operate the Collamat 8600/9100 only by trained personnel.
In case of non-authorized modifications the guarantee will become void.
Before connecting non-standard products, ask your competent technical
supporter.
Peripherals to the Collamat 8600/9100 must only be connected to the mains
socket of the monitor. These devices must be approved by Collamat Stralfors AG.
The specifications of the mains socket are specified in the Technical Appendix.
2.2
Danger notes
The safety symbols and the danger advices on the Collamat 8600/9100 and in this
manual must strictly be observed.
The Collamat 8600/9100 must only be set up in switched off condition.
Before connecting or disconnecting the labeller C8600/9100 to or from the
monitor switch off the monitor.
Monitor and distribution box are only allowed to be opened by authorized
personnel.
Danger of pinching hair, jewellery, ties, clothes etc. into the traction unit !
Danger of injury by cutting fingers in the paper web zone !
Danger of injury in the dancer roller zone of the Collamat 8600/9100 rewinder and
unwinder !
Danger of injury in the case of non-expert use of the Collamat 8600/9100 in the
paper stock control zone.
5999.530-01F 07.04.2006 WM

5