Collamat Etiprint Inline, Operating Instructions Manual

Page: 40 / 188

Etiprint Inline
Commissioning and operating
40
Setting the label sensing (cont.) Now the sensitivity of the label sensing has to be set at the monitor
(see Collamat 8600/9100 monitor operating instructions).
The precision achievable and the suitability of the gaps for sensing
depend on the material used.
With the automatic detection of the sensitivity, the paper strip has
to be drawn forward via the
ON button (at the monitor) until the
label being sensed is standing over a grid (see illustration 15). A
mark on the side of the sensing head pinpoints the exact position
of the label sensing. The automatic detection is started with
ENTER or aborted with ESC . After detection, the value found is
displayed. If the sensing cannot be calibrated on the backing
paper, an error message is displayed.
When specifying the sensitivity manually, the value is entered by
hand. This function is used mainly for calibrating “difficult” labelling
materials.
Fig. 12: Label sensing
1 Mark above the grid
2 Label sensing
3 Label
4 Grid
5 Pull-off ledge
7.3 Setting the dispenser / monitor
The Etiprint Inline dispenser is controlled from the connected
monitor. Adjusting the monitor for good labelling is described in the
handbook for the Collamat 8600/9100 monitor operating
instructions.
The most important settings are:
dispensing speed (speed in m/min)
pre-dispensing
stick-down position (position)
Dispensing single labels (activate label)