Collamat Etiprint Inline, Operating Instructions Manual

Page: 34 / 188

Etiprint Inline
Commissioning and operating
34
Personal safety equipment In principle, wear the following with all work during operation:
Protective work clothing
Protective gloves
Safety shoes
Eye protection
7.2 Settings
Safety
WARNING!
Hazard from switched on labelling plant!
Prior to setting up the Etiprint, the labelling plant is
to be switched off and secured against inadvertent
re-starting (interrupting the supply voltage)!
Before the Etiprint can be taken into service, the following settings
must be made.
Height setting of the Etiprint.
Threading the label strip
Print mode
Inclination of the dispensing applicator
The dispensing applicator press-on roller
Label sensing
Collamat monitor for operating the dispenser
Height adjustment The height adjustment of the Etiprint Inline has a big influence on
the precise and controlled labelling of the product.
If the Etiprint Inline is set too high above the product, the
labels will not be applied properly. The labels can slip or
form bubbles.
If the Etiprint Inline is set too low, this can graze the product
and damage it or lead to bottlenecking.
The exact height setting should therefore be made after a trial run.