Collamat Etiprint Inline, Operating Instructions Manual

Page: 60 / 188

Etiprint Inline
Malfunctions, repair and maintenance work
60
9.4.11 Changing the drive motor
If the drive motor is defective, it will have to be replaced.
Procedure:
Remove the cover of the Etiprint on the reverse side. Undo
the screws for this.
All electrical connections to the motor are detached from the
terminals at the interface (
1 ). The connecting cable ( 2 ) is
freed up (replace the cable ties after refitting). The motor
guard (
5 ) is removed by undoing the fixing screws ( 3 ). Then
the motor can be removed by undoing the fixing screws ( 4 )
and replaced.
Refit in reverse order. The motor connecting cable must be
re-routed using cable ties.
Fig. 21: Changing the drive motor
1 Interface
2 Connecting cable
3 Fixing screw
4 Fixing screw
5 Guard
9.4.12 Clearing the printing head
If the equipment is not to be used for some time, the printing head
on the thermal printer is to cleared (see the operating instructions
for the relevant thermal printer in the appendix).