Collamat Etiprint Inline, Operating Instructions Manual

Page: 115 / 188

5.12 Store program
The Store program function allows to memorize the actual labeller and labelling parameters un-
der a program number. 32 memory locations or program numbers are available. The actual pro-
gram number is indicated as proposal. It can be overwritten or changed on the keyboard. Before
memorizing a safety inquiry prevents a program to be overwritten by mistake. Entering can be ab-
orted by the
ESC key. By depressing the ENTER key, the data are memorized under the entered
program number.
STORE PROGRAM PROGRAM 10
owerwrite ?
as number 10 break [ESC]
execute [ENTER]
User level: programmer
Operating mode: STOP
5.13 Program name
The Program name function is used to file a descriptive designation or an identification under a
labelling program. The program name is entered with the numerical keyboard and terminated with
the
ENTER key. The figures 0...9 as well as the capital letters from A....Z and some special cha-
racters can be entered. When entering a character always start with a figure from 0...9. If a letter
should be entered, the figure can be modified by the
UP and DOWN keys until the wanted letter
appears. The next number has to begin again with entering a figure. After having finished, termi-
nate the function with the
ESC key. The length of the program name is limited to 7 characters.
Example:
To enter the letter A proceed as follows:
Enter 1 . Then increase the figure with the UP key until the letter A appears, then release the key.
In this way all seven digits can be entered one after the other.
PROGRAM NAME
Choice: TEST123
programmer
STOP User level:
Operating mode:
5999.530-01F 07.04.2006 WM

28